Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Modems on VG248

I am using a VG248 with USR v.everything modems. The problem is that calls are dropping after random periods of time. The RAS event log states reason for dissconnect was administrator's request. This is usually caused by line noise. Has anyone been sucessful in implementing RAS over a VG248?

Dave

1 REPLY
New Member

Re: Modems on VG248

To get this working you must have a 6608 blade acting as your PSTN gateway. If you don't, you cannot get this scenario working. You need the latest load for your VG248 and the "43" load for the 6608 (comes with 3.1.3 spD). Without those loads you stand no chance of keeping anything reliable.

I would also contact your local Cisco Account team to discuss other possibilities.

119
Views
0
Helpful
1
Replies