I confiugure my MOH sources to be sent out via Multicast everything seems to working. I can see the mulitcast group being registered in the 6513 with and 8 port T1 blade. And I can see the devices join IGMP group.
The problem is that all phones on the network receive the MOH. But calls coming in from the gateway dont.
When I put two phones on the network on hold I see the VLAN show up in the IGMP group, When I put the phone that is connected through the PSTN on hold nothing showse up in the IGMP group?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...