Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MOH codec

I have been looking and I am wondering how call manager picks the codecs for MOH and can I change that? IF so where are the setting located.

thanks

3 REPLIES
Cisco Employee

Re: MOH codec

Settings for MOH codecs are located under Service --> Service Parameters --> Cisco IP Voice Media Streaming App service. Under the "Service Wide Parameters" section, select the desired codec(s) in the "Supported MOH Codecs" field. (Hold down the Ctrl key to select more than one codec).

Thanks,

Jordy

New Member

Re: MOH codec

If you have a couple codec's in there how do you know which one it is using?

Thanks

Cisco Employee

Re: MOH codec

Short of sniffing the wire for the MOH stream there isn't really a way to verify which codec is being used. However, the MOH codec in use (if more than one is enabled) will be determined by the settings configured in CallManager under "Region" configuration. If all devices are in a single Region, then the codec you select for that Region should determine the type of MOH codec to be used. If multiple Regions are configured, then MOH codec is determined by the Region codec configuration that the receiving device resides in.

Thanks,

Jordy

422
Views
0
Helpful
3
Replies