I would greatly appreciate any help I can receive on a solid way to connect a device with an RCA jack out to provide MOH on a CallManager server using an USB interface. I have it connected now through a device I have never seen but I am getting a lot of static and it sound really bad. Any suggestions will be greatly appreciated.
Thanks for the advice. I think where I will run into problems is the fact that the receiver I am coming out of has no volume. It relies on the television to provide that. The device you sent me does not appear to have a volume control.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...