cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
481
Views
0
Helpful
4
Replies

MOH files are being cut off

cerp
Level 1
Level 1

My MOH is working correctly with my original audio file. However, I created and added a new file that is longer and the file restarts before it finishes. I know there must be some sort of timer, but I can't find it. Any help would be appreciated.

Regards,

Larry

1 Accepted Solution

Accepted Solutions

Rob Huffman
Hall of Fame
Hall of Fame

Hi Larry,

It may be that you are hitting this issue;

CallManager Failure to Load Large MOH Audio Source Files

From this doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00805fef96.shtml

Hope this helps!

Rob

View solution in original post

4 Replies 4

Rob Huffman
Hall of Fame
Hall of Fame

Hi Larry,

It may be that you are hitting this issue;

CallManager Failure to Load Large MOH Audio Source Files

From this doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00805fef96.shtml

Hope this helps!

Rob

Rob,

That was exactly what was happening. I made the changes and dropped the file into the MOH file again and it now works properly. Thank you for the help.

Larry

Hi Larry,

You are most welcome! Thanks for letting us know the solution and for the nice rating :)

Take care,

Rob

Hi

I have the same problem, the only difference is that it is not working.

There are large files in MoH that work fine. But last week we added some small files for the attendant console.

These 2 files are cut off before the end. It are 2 files of 300 Kb and about 25 seconds. 2 seconds before the end, the loop rebegins.

All the timers are correct and all the other MoH files play out very well.

What can be the problem?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: