Oh yea, you sure hit a sore point. Cisco told me it wasn't possible. So...here's how to do it.
Find the "Send H225 User Info Message" Service Parameter and change it to "Use ANN for ringback" which references the Annunciator since the Gateway is hard-wired to play those beeps and doesn't understand anything else.
Let me know if that works...to be honest, I went through so many steps with TAC that my config is a little messy with what I'm sure is a lot of orphaned steps. You may have to create a silent .wav file to set as the MOH source, but I think the Service Parameter should do it. If it doesn't work, I'll go through some other stuff. It's been a while though so I have to rehash it.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...