Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

MoH

In CCM 4.2, what is the best way to change the MoH source for all phones? You can't do this through the device pools in 4.2.

Thanks,

2 REPLIES

Re: MoH

You can do this with a common profile. Take a look at the following link.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a008055b55a.html

Hope this helps. If so, please rate the post.

Brandon

Re: MoH

Is this just one site or multiple sites ?

You can set a service parameter (Default MOH user audio source and network audio source) in service parameters and that will apply to all phones. phone should fall back to service parameter setting if nothing is set under device or device pool level.

138
Views
0
Helpful
2
Replies
CreatePlease to create content