I have already done a VoIP test and was successful thanks to Paul Cameron (Cisco Techie). The test involves extending our telephone network to one of our branch office. We pull an extension from our current PABX and move it to this branch office, using PLAR/OPX method and a 1024kbps lease line.
How do I monitor the voice traffic,or which signal/frame should I use to determine the amount of voice traffic is used on this 1024Kbps dedicated lease circuit. Im using LLQ as my priority method.
Currently Im using Etherreal to capture network traffic. Is there any way we can determine this using Cisco IOS CLI ?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...