Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

MRP's and MGCP

I have an MRP200 with 2 VIC-2FXO cards installed. The entire MRP is configured MGCP. The endpoints on the card in slot 0 show registration in Call Manager; the endpoints on the card in slot 1 do not. When I type "show mgcp endpoint" from the MRP CLI, all 4 FXO ports are listed. Does anyone have any suggestions? Why do the other ports not register?

2 REPLIES

Re: MRP's and MGCP

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Cisco Employee

Re: MRP's and MGCP

Can you provide the "show version"? Try turning on "debug mgcp packet" then doing a shut/no shut on the voice-ports in slot1. Does the MRP send RSIPs? Does the CM respond with AUEPs and RQNTs for offhook notification?

119
Views
0
Helpful
2
Replies
CreatePlease to create content