MRP3-8FXS module in iCS7750 unfunctional after upgrade
MRP3-8FXS module had IOS ics7700-sv3y10-mz.122-8.YN.bin running in ICS7750, I upgraded it to ics7700-sv3y-mz.122-16a.bin . After upgraded this module became unfunctional, system manager detects this is an unknown type module giving error code 200. The worst thing is I even couldn't access it by SAP through console( I connected to SAP via console then press ctrl \ and enter the slot number , but couldn't access this module . Btw,I have the other MRP300 is OK).I reoloaded the whole box, same problem.
Re: MRP3-8FXS module in iCS7750 unfunctional after upgrade
I can tell you that none of those mainline or T versions of code will work on that module. The latest one is ics7700-sv3y-mz.122-11.YV.bin, or at least it was as of about a week ago. Unfortunately, I'm not sure how to access the the MRP to reload the flash in the current state.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...