I have a customer that has run out of lines on their 7960 phones. They have a single appearance key of their main number on 10 phones. Of course when that line is active they can get any more calls. Is there away to setup hunting for that many phones. No I can not upgrade to CCM4.0 because I am running IPCC which is not working with CCM 4.0 yet.
You can have the same main number apperance on 10 phones, and configure them to ring one after the other. Partitions and CSS help make this possible, and the link gives you an example of that (although it shows that on a single phone):
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...