Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

multi-homed CCME

Hi all,

I hope someone can help me with a multihome setup for Call Manager Express.

We have a 2811 as Internet-Gateway, Firewall, VPN and VoIP-System. We use SIP for external phone calls and have a SIP provider.

We got a second Internet link for failover and traffic sharing.

I have a few static routes to send all IP traffic for the SIP provider over the second ISP. The rest goes to the first ISP.

configuration snippet:

ip route 0.0.0.0 <GW ISP#1> 1

ip route 0.0.0.0 <GW ISP#2> 2

ip route <VoIP Net> <GW ISP#2> 1

ip route <VoIP Net> <GW ISP#1> 2

I also have two pools for NAT. I used bind (voip - sip) to bind the outbound sip traffic to the interface to ISP#2.

I'm looking for PBR, but didn't found the interface were I can configure the policy route-map for the CME.

Each ISP link has its own static IPs. No BGP possible.

Any comments are appreciated.

Sven.

2811

IOS 12.4(15)T1

CME 4.1

1 REPLY
Silver

Re: multi-homed CCME

You can configure the policy on the interface which point to the gateway

113
Views
0
Helpful
1
Replies
CreatePlease to create content