Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multicast MOH not working on e1 blade

I have enabled Pim -sparse-dense-mode on voice vlan 107

And have added the IP multicast routing command to the msfc.

The tac tells me this The CCO documentation states;

? Gateways (unicast and multicast)?VG200 (MGCP), Access gateway Module (Catalyst 4000 card), Catalyst 4224, WS-6608-T1/E-1 (Catalyst 6000 8-port PRI card), DE-30+, and DT-24+

Unfortunately however the truth is that currently Multicast MoH support in gateways is limited to IOS platforms that support 12.2.2XN and the above list of gateways is presently incorrect.

Is this correct.

1 REPLY
Cisco Employee

Re: Multicast MOH not working on e1 blade

That sounds right to me that you are correct. To my knowledge 12.2(2)xn version of IOS is the only gateway that can do multicast MOH.

Thank you,

-Mckee

95
Views
0
Helpful
1
Replies
CreatePlease login to create content