We have installed CM3.0 and Unity 2.4 with Cisco 7960 phones. When trying to set up call handlers, I can't get Unity to ring a phone. I have installed the latest TSP drivers and the Cisco Wave drivers ( or so I thought). When I go to Control Panel/Multimedia, under the playback and record devices, I see only the Dialogic wave drivers and Cisco TAPI record ports listed. Shouldn't there be a telephony device or something listed as well? Does this mean I don't have the Cisco wave drivers loaded?<br><br>Help.<br><br>
I believe you have the Cisco Wave driver installed correctly. You should only see the Cisco wave drivers listed in the Multimedia ports. The Av-Cisco Service provider will be listed in following location in the control panel.
WinNT 4.0: Telephony->"Telephony Drivers"
Win2000: "Phone and Modem Options"->Advanced
If you can receive calls and record messages you probably have the AvCiscoTsp setup correctly. You will want to call our Tech Support to help you figure out exactly what is going on. The Call Search space for the uOne ports might not be configured properly. If you using a multiple switch configuration that could also be configured incorrectly.
Aaron Belcher Software Engineer Active Voice email@example.com
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...