Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bronze

Multiple BRI Interfaces Grouping for dial-peers

Hi,

Found the following information <http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800ca716.html> that can configure trunk groups for PRI and assign to dial-peers, is there any change something like this can be performed with a number of BRI interfaces so I do not have to have triple the dial-peers.

Thanks.

1 REPLY
New Member

Re: Multiple BRI Interfaces Grouping for dial-peers

I don't know of any equivalent "trunk-group" config for BRI interfaces. As far as I know, this is reserved for bundling DS0s. To consolidate BRI traffic to a fewer number of dial peers, maybe you could try voice translation profiles with the new 12.4 code. Here is a link:

http://www.cisco.com/en/US/partner/tech/tk652/tk90/technologies_configuration_example09186a00803f818a.shtml#related

124
Views
0
Helpful
1
Replies