Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Multiple Line Appearances - Single Port

I guess I'm missing something... It seems like it would be fairly simple to set up multiple extensions to ring to a single port, sort of a reverse hunt but I can't figure out how to do it. Specifically, I have multiple published numbers that I would like to point to a specific device (in this case an analog port on a VG248). Any quick pointers?

Thanks,

Jim

2 REPLIES
Cisco Employee

Re: Multiple Line Appearances - Single Port

Quick one I can think of is to set up multiple translation patterns on the CM to translate the multiple numbers to one single DN on the VG248.

-ben

New Member

Re: Multiple Line Appearances - Single Port

Thanks,

That looks like it will work!

- Jim

104
Views
0
Helpful
2
Replies
CreatePlease to create content