The Initialization Wizard checks to make sure that the JTAPI and web user accounts and passwords are correct. The Initialization Wizard also checks to ensure that a compatible Cisco CallManager level is installed. The Initialization Wizard does not allow you to continue unless these values are all correct. ever copy or paste this configuration into a live system. Pay attention to the fact that you have JTAPI and The Switched Multimegabit Data Service (SMDS) Interface Protocol (SIP) triggers that point to the same applications and have the same phone numbers assigned to them. The CCN subsystem SIP gateway address points to the Cisco SRST router, and the CCN subsystem JTAPI points to the Cisco CallManager. The MWI parameters are the default ones and these are not used. You cannot get MWI to work in Cisco SRST mode no matter what is configured
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...