I'm configuring intercom functionality with speed-dials and auto-answer. When the speed-dial is pressed, the called party only wants to be able to hear. He doesn't want the calling party to be able to hear him. Is there a way in CM 3.3(2) or any other version, to configure a line to mute on answer? Thanks in advance.
I think a better approach would be a service that presented a menu. Choosing a person on that menu would post the appropriate CiscoIPPhoneExecute commands to direct the callers phone to send an rtp stream and the callee's phone to receive it. When you tell the phone to receive or send, it comes up muted - presumably to avoid the possibility of remote eavesdropping.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...