Using Unity 3.0 and CM 3.1(2c). <br>Had MWI lights working on phones. It has stopped working.<br>From an IP Phone we can manually light MWI using the MsgWaitingON extension and are able to turn it off.<br><br>On the Unity server in Event Viewer under Application Log found the following:<br><br>FAILED TO SET MESSAGE WAITING LAMP FOR TEST3, EXT 4009, SWITCH 1, CLUSTER 0, REASON NO SUITABLE PORT.<br><br>I have checked the TSP settings everything matches.<br><br><br><br>
A few things I've run into... 1) Make sure that on the ports in the SA you have the extension numbers for the ports defined. 2) Also on your ports make sure that there is at least one port availble to Set MWI
Have you introduced any new translation/route patterns since they were working?
Found problem. This is a dual integration. Somehow, someone changed the ports so that all eight were assigned to the PBX switch and none to CM. I changed the PBX to use ports 1 to 4 (4-port Dialogic card) and ports 5 to 8 for CM. Stop/Restart and all is working.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...