Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MWI on analog phone attached to FXS port on 2600?

I have an analog phone that has a message waiting lamp, but I have been unsuccessful in getting it to light up. I know the VG248 can do it, but can an FXS port in a 2600 using MGCP pass MWI? If so, what's the trick? Thanks!!

2 REPLIES
Cisco Employee

Re: MWI on analog phone attached to FXS port on 2600?

I'm pretty sure it cannot. You might want to look at the ATA-186 or ATA-188 for these ports if the VG248 is too high-density. The ATAs support audible MWI (stutter dial tone, no light).

New Member

Re: MWI on analog phone attached to FXS port on 2600?

Thanks... if you're pretty sure it can't be done, I will stop trying to make it work.

192
Views
0
Helpful
2
Replies
CreatePlease login to create content