I have a qsig trunk setup from a Avaya CM to a CUCM 4.2(3)sr2b via 3845 MGCP gateway. I am not able to make the MWI to work. I have made sure that the MWI on/off numbers match in CM and Unity and I have a route created from CM for the Avaya IP Phone extension. Unity ports have access to it and I am not discarding any digits on the gateway. I have also made sure to change the cisco00002.ini to displayupdate=yes. Please help!!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...