Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Naming POTS analong lines on CME

We have a CME with 4 analog POTS lines (for FAX, speaker phone, etc). Can someone please give me the command to enter so that we can assign a name for each of these analog ports which will appear on the internal extensions for my users?

1 REPLY

Re: Naming POTS analong lines on CME

voice-port x/y

station-id name

station-id number

PS: Please remember to rate posts!

125
Views
0
Helpful
1
Replies
CreatePlease to create content