Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Nat support for VoIP

I have troubles with a VoIP connection between 2 IOS routers through the internet. One of them has a public address and the other a private one, so there is another router translating with NAT, but the voice is working only in one direction (private-to-public).

I think the IP address of the "private" router is going inside the H.245 setup message.

Does anybody know any document or example configuration for a similar case?

2 REPLIES
Community Member

Re: Nat support for VoIP

For my opinion, the easiest way to achiev voice going through both way is to use port forwarding system or port triggering.

It is very simple rule set that forward the VoIP packets to the private GW whenev UDP packet with H.323 udp port hits the NAT router.

Community Member

Re: Nat support for VoIP

Hello,

We have already encounter this problem.

We solve it by upgrading the IOS of our routeur that was doing the NAT to ENTERPRISE PLUS/H323 MCM 12.2.6.

You can test an other solution that consist in using a VPN.

Regards

144
Views
0
Helpful
2
Replies
CreatePlease to create content