Anyone tried to integrate the NEAX 2000 to a Cisco 3745 with E&M? MGCP, CCM 3.3.2, 3745 w/NM-HDV, VWIC-2T1. Controller is up, no errors. Debug shows Cisco waiting on NEC answer. You can hear digits and my voice when monitoring T1 ds0 at NEC recieve side.
Oh, yes, Iwould very much appreciate the integration details! The type of tie-line you set up, any info on the PBX side, and the router cfg for sure. Thank you, please post the info or you can email me if you like.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.