Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NEC NEAX 2000 and 2400 PBX Integration with Cisco Callmanager

We have a job coming up where we will need to integrate a NEC NEAX 2000 IPX PBX and a NEC NEAX 2400 PBX with Cisco Callmanager Buisness Edition version 8 that will be installed at a new building. I am hoping someone has done an integration similar to this and may have some information on how to integrate the NEC with Cisco Callmanager and Unity Connection.

4 REPLIES
New Member

NEC NEAX 2000 and 2400 PBX Integration with Cisco Callmanager

Hello Joel,

Did you migrate off the NECs yet?  I have a similiar job coming up and was looking for some advice.

New Member

NEC NEAX 2000 and 2400 PBX Integration with Cisco Callmanager

Hi,

Have the same problem, do you find something?

NEC NEAX 2000 and 2400 PBX Integration with Cisco Callmanager

You can use T1 QSIG for the integration with CUCM.  For Unity Connection, you will need TIMG/PIMG and there are integration guides available for the NEC via Cisco.

Hailey

Please rate helpful posts!

NEC NEAX 2000 and 2400 PBX Integration with Cisco Callmanager

Hi Joel,

currently I have similiar case with you,

BE6K (CUCM 9.x) with NEC Neax 2400 IPX PBX,

have you integrate them?

I was looking for some advice.

Hi David,

"You can use T1 QSIG for the integration with CUCM",

do you have some guide to do this thing?

please advise,

regards,

Ovindo Prastyo Utomo

1836
Views
0
Helpful
4
Replies