Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need help in call disconnection reason

hi all,

I have a CME version 4.1(0) on 2821 router with IOS 12.4(15)T5.

i configured the following dial-peer:

dial-peer voice 15 pots

service aa

destination-pattern 8...

port 0/2/1

and when i try to call 8320 i get a fast busy tone

i tried csim start command with debug voice ccapi inout and get the messages shown in the attachment.

Note: the service aa command under the dial peer is used for auto attendant purpose.

could any one please help me to know the reason of this?

thanks

2 REPLIES

Re: Need help in call disconnection reason

csim start should not be used for any real testing, it can cause wierd things for wierd reasons, and I have proved csim start to be the only cause of my problems many times. Try it from a phone then resend everything if it still fails...

HTH,

Chad

Re: Need help in call disconnection reason

Also if you tried it from a phone, was it an ip phone? I don't believe you can have that work like you want it to, unless it pots incoming dial peer. try

dial-peer peer voice 15 voip

incoming called-number 8320

session target ipv4:

codec g711ulaw

no vad

Cheers,

Chad

111
Views
0
Helpful
2
Replies