I setup hotdial in call manger using Translation Pattern Configuration and it is working as i want it. How can i hide calling number (calling party tranformation mask) or display some other number so that caller don't see what number is getting dial when user pickup the headset.
Link below does not talk about display calling number.
I'm not clear which you are trying to block: the calling or called party information.
Calling party presentation can be set to Restricted on the translation pattern. Called party on the other hand isn't so easy. To my knowledge, there is nothing within CUCM that will prevent the calling phone's display from updating with the translated destination pattern. It would be possible to do this once the call gets to an IOS gateway using a very complex SIP profile to modify the remote-party-id header; however, this doesn't scale and is rather tricky. On top of that, there would be a delay before the router responds with a 180/183 updating the header so CUCM would show the translated destination for a second or two.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...