Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Need to send 3 digits as calling party number .

Hi,

What do I need to configure on the CM to pass jst the last 3 digits as the calling party number to the telco ?

I am currently sending the full 8-digits i.e Calling Party Number i = 0x0081, '24588001' but now the telco needs that i jst send the last 3 digits.

Thanks

Brgds

renzil

2 REPLIES
New Member

Re: Need to send 3 digits as calling party number .

Hi Renzil,

The below link should help you in configuring on the CM

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00802e0689.html#wp1044110

If your gateway is H.323, we can configure translation pattern on the gateway to manipulate the calling number.

Let me know if you have any questions.

Thanks

Venky

Cisco Employee

Re: Need to send 3 digits as calling party number .

on the Route Pattern, set Calling Party Transform Mask to XXX

149
Views
0
Helpful
2
Replies