Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Need to test POTS dial Peers

I have a c2821 running (c2800NM-SPSERVICEK9-M), Version 12.4(3c). I need to test my POTS dial peers on the roter but could not find any commands for that. I have seen that command test pots port dial was introduced on the Cisco 800 series, 12.1(2)XF. Do any one know if that command still exists and if there is some IOS software that fit my c2821?

1 REPLY
Cisco Employee

Re: Need to test POTS dial Peers

Hi,

You can test your pots dial-peer by using the following command:

csim start 97135552121

This number will reflect the pots number and you can turn on the debugs to see if the call goes out. Ofcourse there will be no audio.

269
Views
0
Helpful
1
Replies