Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Netmeeting Problem

Hi to all, I have the following problem. I want to configure Netmeeting for a lab but there is a proxy involved between the router and the switch, that gives dynamic IPs to the computers to the lab... So each time the pcs have different IPs from a range of 10.0.xx.xx... But the dial peer statements need a static IP right?

For example

dial peer 1 voip

session target 194.219.xx.xx...

Any suggestions for my case? Do I have to change the configs at Netmeeting also?

Thanks in advance!

  • Other Collaboration Voice and Video Subjects
1 REPLY
Bronze

Re: Netmeeting Problem

Step-by-Step Instructions

To configure Microsoft NetMeeting to work with the VoIP gateway, use this procedure:

Open Microsoft NetMeeting and choose Tools > Options.

Click the General tab and enter your First name, Last name, and E-mail address.

On the Audio tab, click Advanced.

Check Manually configure compression settings and select CCITT u-Law, 8.000kHz, 8 Bit, Mono from the Preferred codec for audio compression drop-down list. Click OK on both dialog boxes.

From the NetMeeting Tools menu, choose Options > General > Advance calling.

In the Gateway settings area, check Use a gateway to call telephones and videoconferencing systems and enter Gateway IP Adress in the Gateway field.

This URL should Helps You:

http://www.cisco.com/warp/public/788/voip/netmeeting-ios.html

92
Views
0
Helpful
1
Replies
This widget could not be displayed.