Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

network announcements at sip network.

I'm using cisco GW 3500, sending traffic from SIP to H323

I have problems with toll-free numbers because they have "network annaoucements" - the "connected" signal is not sent and the timers expire by thr time the annaouncement end.

other numbers are working fine ( and toll-free numbers that don't have those announcements)

I want to replace the annaouncement signal with connected signal . (20O OK at the SIP).

I think the solution should be with the command "progress_ind" but no success yet.

here is the one of the dial-peers that I tried:

dial-peer voice 1800 pots

huntstop

preference 1

destination-pattern 18007623726

progress_ind progress enable 8

progress_ind connect enable 8

port 3/0:D

Thank You

Amos

  • Other Collaboration Voice and Video Subjects
2 REPLIES
New Member

Re: network announcements at sip network.

I have seen similar problems with international calls and toll-free numbers being disconnected... the problem was resolved by increasing T310 timers to 120000 msec.

New Member

Re: network announcements at sip network.

I getting to the DTMF menu but it is still in "ringing tone" mode , so even when I press the digits - it doesn't help . is there any way to transfer it through the signalling ?

Amos

97
Views
0
Helpful
2
Replies
This widget could not be displayed.