I am running Unity 3.1.5 vm-only and Ex55 sp4. I've run into a situtaion very similar to CSCdx56923, in which new VM messages cannot be played via the phone but are accessible via an email client. However, it does appear that the Priority field in the new msgs is being set correctly. This is happening after a new Exchange server is added to site and some mailboxes are moved to the new server. Leaving msgs works, MWI works, Can see and play VM through email client. All SEEMS well, except new messages cannot be played via the phone: "You have x new messages. To play new messages, Press 1." When you Press 1, she says, "New messages. End of new messages. You still have x new messages." Rebooting Unity helps (that is, you can then listen to the msgs that were left until the server was rebooted and notifier ran, etc.) UNTIL a new message is left, and then no new messages can be listened to. Any help on this one would be appreciated. Thanks,
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...