Restrictions for Configuring MGCP Gateway Support • Support for adding the Cisco VGD 1T3 as a Cisco Unified Communications Manager controlled MGCP gateway requires Cisco Unified Communications Manager version 6.1(2), 7.0(3), or later. • Only one Cisco VGD 1T3 gateway is supported per Cisco Unified Communications Manager subscriber node. • Integrated access is not supported when you control voice traffic using MGCP and Cisco Unified Communications Manager. Integrated access is when the channels on a T1 interface are divided between a group used for voice and another group used for WAN access. • T1 protocols, such as QSIG T1 FGD, and PRI NFAS, are not supported with MGCP.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...