Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NM-CUE on another NM-xxx module

Is it possible to install a Cisco Unity Express on another type of module for Lab purposes (for example, on NM-IDS or NM-NAM)? The hardware is exactly the same, and there is no way to say, what module it is without looking at the front plate. The only "logical" difference is in what module report as an FRU code (device type), which is written in EEPROM BIOS. So, could it be any way to re-flash BIOS with another FRU code, and install NM-CUE over that?

2 REPLIES
Hall of Fame Super Gold

Re: NM-CUE on another NM-xxx module

There is no documented way, if you can find one that would be by reverse engineering and completely unsupported by cisco.

New Member

Re: NM-CUE on another NM-xxx module

I'm not going to get support from Cisco for this module - I need it for Voice Lab practice, and I don't want to spend a couple grands. I have a couple decommissioned NM- modules around, and was wondered, if I can get some use of them.

641
Views
0
Helpful
2
Replies