We are currently using a NM-HDV-1T1-24 in a 2621 to act as a gateway between our CCM and our Definity PBX. We would like to upgrade the HDV module to a NM-HDV-2T1-48 and use the 2nd T1 to tie this Definity PBX to another Definity PBX at a remote site via a 10meg IP over Sonet link.
We are looking for documentation on connecting a Definity PBX and a CCM system into another Definity PBX via a 2621 (or similar device) w/ a NM-HDV-2T1-48.
Just connect the other Definity PBX to the 2621 just like the first one.
You can either route the calls from one PRI to the other using POTS dial-peers on the 2621, or you can have the CallManager do this with route patterns. There is nothing particularly challenging about this configuration compared to what you have already done.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...