NM-HDV-2T1 PRI's in a 3640 going to Callmanager 3.22 no inbound working

[Aaron D]

Outbound calls work fine, inbound calls say call cannot be completed. Calls are hitting the router but it states destination not found. Any ideas?

thanks,

Aaron

[thusain]

Is this ISDN. We need to look at some debugs. Are you doing MGCP or h323 to the call manager. debug isdn q931 should give you a better idea of whats happening.

[trailman73]

Are your translation patterns working? Are you setup for 4,7,10 digits

? I have the same card and a 3745 router, with no problems.

Geoff

[dconstantino]

The dial-peers are setup as VoIP not POTS right and you have the proper settings. Again knowing what protocol you are using would help H323 or MGCP.

[andy.chapman]

Hi there,

We are having the same problems too. Now, the problem is intermittent but is still causing us some headaches.

The setup is as follows:

CCM 3.2, SP_E; 3620 Router with HDV PRI and MGCP configured.

Unfortunately I don't have a copy of debug isdn q931 but I can tell you that one of the lines states:

"Circuit/Channel not available"

Does anyone have any ideas?????

Thanks in advance

Andy