Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

NM-HDV DSP resource sharing

I have a NM-HDV module with two PVDM-16 modules and a VWIC-1MFT installed in a 2811. I have a VIC2-2FXO card that I need to install into one of the HWIC slots. Is there any way that I can share the DSP resources from the NM-HDV for the new FXO card or do I have to install new PVDM2 dsp modules in the 2811?

2 REPLIES
Silver

Re: NM-HDV DSP resource sharing

Nope. You cannot share the DSP resources from the NM-HDV in this case.You have to go for a new PVDM2 dsp modules

Community Member

Re: NM-HDV DSP resource sharing

Can we put PVDM2-64 on NM-HDV network module ?

Because we are using NM-HDV module with PVDM12, we want to add PVDM2-64 on this module. will it possible?

Regards,

283
Views
0
Helpful
2
Replies
CreatePlease to create content