Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NM-HDV2-1T1/E1 won't show up

I just installed a NM-HDV2-1T1/E1 in a 2610XM and have 12.3(14)T6 ip voice IOS on the router. I can see the NM when I do a 'show diag' but, the NM doesn't show up in the configuration at all. Any help would be appreciated.

4 REPLIES
Cisco Employee

Re: NM-HDV2-1T1/E1 won't show up

What do you mean by "doesn't show up in the configuration?" Do you mean that you are not able to configure the voice port?

New Member

Re: NM-HDV2-1T1/E1 won't show up

Yes, I am not able to configure the voice port. The router will register with Call Manager but there is no controller T1 1/0 port for the router to do a 'no shut' on so the Call Manager config fails.

Super Bronze

Re: NM-HDV2-1T1/E1 won't show up

Hi

I think you need the command:

card type T1 1 0

or something along those lines - tells your card whether to be an E1 or a T1, I've probably got the 1/0 wrong though! :-)

Have fun

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: NM-HDV2-1T1/E1 won't show up

Looks like this might have worked. Thank you greatly, Aaron.

185
Views
5
Helpful
4
Replies
CreatePlease login to create content