This section is true for the DSP Single In-line Memory Modules (SIMMS). The High Density Voice Network Modules (NM-HDV) Farm module ships with two SIMMS and is able to handle three additional SIMMS. Each SIMM contains three DSPs. Each DSP supports four transcoding sessions or one conference bridge. Four transcoding sessions are supported for 729-711. If you use the Global System for Mobile communication (GSM), then the DSPs can handle three transcoding sessions. Therefore, the maximum number of transcoding sessions that a five-SIMM configuration supports is 60 transcoding sessions. The maximum number of conference calls that a five-SIMM configuration supports is 15."
Does it mean that NM-HDV2-2T1/E1 also contain shipped in DSP ?
In the first gen module NM-HDV, you could order them with or withoutDSP chips in it. The NM-HDV-FARM was sold as a transcoding/conferencing resource and comes with 3 or 5 DSP chips in them. The NM-HDV2s are not available in this flavour. You just need to get the PVDM2's separate. Also the NM-HDV2s have only 4 slots.(not 5).
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...