no announcement messages for mobile calls and no busy tone on and off
AS5300 works as a gateway to send traffic to another as5300.
The user cannot hear the announcement messages even though I got " Progress Ind i=0x8188 in-band info or appropriate now available' using debug ISDN q931.
The user cannot hear the busy tone for proper calls on the off .
I have checked all the VOIP document on cisco's website but can not find the solution. Does it because PBX at another site cannot send the voice ammouncement message or busy tone signals? The PBX connects to PSTN using NO.7 and when the destination user is busy the caller can hear the busy tone but in other cases such as the trunk is busy the user cannot hear the busy tone.
Re: no announcement messages for mobile calls and no busy tone o
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...