Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No busy tone on cme 3.3 ip phones

Hello,

I am running cme 3.3 and callers to do not get a busy tone, when the destination that they are calling is busy. The call simply cuts of without the caller hearing a busy tone. I have tried using the "voice call convert-discpi-to-prog" command and it did not seem to make a difference. Do i need to reload the router after issuing this command?

Any idea how to resolve this?

Thanks

1 REPLY
Silver

Re: No busy tone on cme 3.3 ip phones

You can force the gateway to generate a ring back by issuing the progress_ind setup enable 3 command. Configure this on the VoIP pointing to the Cisco CallManager.

!

dial-peer voice 500 voip

destination-pattern 5...

progress_ind setup enable 3

!-- Forces ring back tone for this peer.

session target ipv4:10.200.73.15

codec g711ulaw

!Note: In case of multiple VoIP peers that can be matched, make sure to configure this on all of them.

This URL should help you :

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a0080111b80.shtml

102
Views
0
Helpful
1
Replies