Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

qni
New Member

No busy tone

When I ring a external international number that is engaged from an IP phone I am not getting any busy tone.

When I dial the same number from a mobile phone I am getting a recorded message from the carrier saying that the number can't be connected.

Is there a configuration on the CCM to pass the engage message to the IP Phones?

2 REPLIES
New Member

Re: No busy tone

What kind of PSTN connection and voice gateway do you have? I have a VG200 with a PRI line and a T1 CAS line. I get the same thing from my T1 CAS line, but NOT from my PRI line. My voice gateway is setup in MGCP mode.

Bronze

Re: No busy tone

Hi,

try it with : ""voice call convert-discpi-to-prog"" global command.

Hope this helps

Regards

Mehmet

114
Views
0
Helpful
2
Replies