No ports to configure on Unity 3.1.3, not using sp3
I have tried installing and reinstalling different versions of the TSP, but when I go to test the connection it always fails, and I do not have any ports listed in the Status Monitor. I have tried version 1.00.32 and 1.00.39 of the TSP, but I get the same results. I'm running on Win2000 SP2 and EXCH2000, connecting to Call Manager 3.2 I don't know what to try next to get the ports to show up. In Unity System Administration I show that there should be 4 ports.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...