I have a translation rule on a cme-1 that translates DID 2346000 to 5000. I then have a voip dial-peer on cme-1 for the pattern 5000 and the session target as the IP of a second cme-2, that i want to forward the call to.
The call connects, but the caller does not hear ring back, as ext 5000 rings on cme-2.
The call on cme-1 is an incoming call via T1 PRI. I have tried the progress-ind command under voip dial-peer in cme-1, but that has not fixed the problem.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...