Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No Ringback across a T1

I have IP Phones, Call Manager 3.1 and a 3660 with a PRI for in/out calls and a T1 to an office that has IP Phones and a 3660.

When I call from an IP Phone to an IP phone at the office with the Call Manager, it works fine. When I call from an IP Phone to an IP Phone at the office on the other side of the T1, I don't hear ringback. It doesn't matter whether I am dialing the extension number or the whole outside number. The phone at the other end does ring, though.

Any suggestions?

2 REPLIES
New Member

Re: No Ringback across a T1

have you tried any of the progress_ind commands?

for example, without progress_ind setup enable 3 on this dial peer pstn callers do not get ringback from my 3640

dial-peer voice 3000 voip

destination-pattern 3...

progress_ind setup enable 3

session target ipv4:192.168.1.240

dtmf-relay h245-alphanumeric

codec g711ulaw

you situation is a little different but...

http://www.cisco.com/warp/public/788/voip/ringback.html#backtwo

New Member

Re: No Ringback across a T1

When the users answers can they speak to each other?

141
Views
0
Helpful
2
Replies
CreatePlease to create content