07-29-2002 07:38 AM - edited 03-12-2019 08:07 PM
I am using 3640 as a h323 gateway, using ios 12.2.(10a).
i encountered a strange problem, when i call from ip phone to mobile phone from one mobile operators, i can't hear a ring back tone. my country has 3 mobile operators, when calls are made to the other 2 mobiles operators number, and all fixed lines it is working fine, can hear ring tone.
Below is my config:
dial-peer voice 100 voip
destination-pattern 6370....
session target ipv4:10.228.204.5
codec g711alaw
!
dial-peer voice 200 pots
destination-pattern 9T
direct-inward-dial
port 2/0:15
!
what am i missing?
07-29-2002 07:51 AM
The following doc has some good tips on troubleshooting no ringback:
http://www.cisco.com/warp/public/788/voip/ringback.html
Hope this helps
07-31-2002 01:44 AM
Did you try putting "progress_ind connect enable 8" under the dial-peer voice pots?
Best regards,
Bruno
08-01-2002 10:20 PM
Hi,
The link of rosalasa is fine.
just write on the dial-peer pots the command "progress_ind alert enable 8"
If you cannot find it with the help command it's normal.
I also noticed that without this command, I had lots of delay for the ring tones for calls from IP Phones through GSM phones. For example, when I put the IPphone on hook before the called phone answered, this one continued ringing during about 2 seconds.
Bye
JP
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide