Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

no ringing tone on 7960

I f i place call from ip phone to pstn phone , i do not listen any ringing tone on my ip phone? Do i need something to set up?

Martin

3 REPLIES
Community Member

Re: no ringing tone on 7960

It sounds like you need to enable the progress indicator on your gateway. On our VG200, I have the following command in my dial-peer section:

progress_ind setup enable 3

Good Luck.

Steve

Cisco Employee

Re: no ringing tone on 7960

It depends on the gateway and the telco. If you have an h.323 gateway and you are calling out to the pstn you need to do a progress_ind alert enable 8 on the outbound pots dial-peer you are hitting. If you are doing Pri you need to look at the ISDN messaging to see if you are getting alerting back from the telco. A little more info on your setup would be helpful. Like the type of voice interface and the gateway you are using.

Thank you,

-Mckee

Community Member

Re: no ringing tone on 7960

We are using H.323 gateway which is doing PRI. I have changed calling and called numbers at debug isdn q931. I see Alerting is coming but not leaving from the router. And if I type command progress_ind progress enable 8 on

the dial-peer nothing gonna change. Any ideas?

Martin

ISDN Se1/0:15: TX -> SETUP pd = 8 callref = 0x0D50

May 16 13:32:03: Bearer Capability i = 0x8090A3

May 16 13:32:03: Channel ID i = 0xA9839F

May 16 13:32:03: Calling Party Number i = 0x81, '11111111', Plan:ISDN, T

ype:Unknown

May 16 13:32:03: Called Party Number i = 0x80, '22222222', Plan:Unknow

n, Type:Unknown

May 16 13:32:04: ISDN Se1/0:15: RX <- CALL_PROC pd = 8 callref = 0x8D50

May 16 13:32:04: Channel ID i = 0xA9839F

May 16 13:32:10: ISDN Se1/0:15: RX <- ALERTING pd = 8 callref = 0x8D50

May 16 13:32:30: ISDN Se1/0:15: TX -> DISCONNECT pd = 8 callref = 0x0D50

May 16 13:32:30: Cause i = 0x8090 - Normal call clearing

May 16 13:32:30: ISDN Se1/0:15: RX <- RELEASE pd = 8 callref = 0x8D50

May 16 13:32:30: Facility i = 0x91A115020153020122300DA10530030201008201

120
Views
0
Helpful
3
Replies
CreatePlease to create content