No Slot 0 when adding 2651XM-V MGCP Gateway in CCM 3.3.3
When you specify 26xx from the list of gateways under CCM 3.3.3, there is no slot 0 available in order to configure an AIM-30 module. Slot 1 is the only slot listed which is specifically for NM-HDV, and NM-HDA modules.
Has anyone else come across this problem ? I would appreciate if anyone running 3.3.2 could possibly try and add a 26xx gateway and let me know whether slot 0 is available to configure ? This would prove whether the upgrade form 3.3.2 to 3.3.3.
Re: No Slot 0 when adding 2651XM-V MGCP Gateway in CCM 3.3.3
There is a similar know bug CSCeb23199 on www.cisco.com in which, for the 3700 series gateway the slot0 is missing . Please check for more details on the Bug Tool Kit. This can be resolved by using one of the patches available in Software Center.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.