Nortel Merdian and Cisco Gateway T1-PRI integration
Is there a definitive guide to this type of integration. For example what Nortel PRI cards have been tested, whether there are features that cannot be accomplished with Q.931 as opposed to QSIG. Detailed configuration examples that list the pitfalls associated with this type of integration. Etc.
Re: Nortel Merdian and Cisco Gateway T1-PRI integration
I think the short answer is that for PRI read Basic Telphony. For Qsig read Suplementary Services. From then on it depends on the completeness of the Qsig implementation on both the Nortel PRI cars - i.e revision of the switch software; the same goes for the release of IOS and CallManager if in the equation.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...