cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
261
Views
0
Helpful
2
Replies

Not all IP Phones reconnect to Callmanager after SRST

rbradfield
Level 2
Level 2

we had a site go over to SRST the other day, and the IP phones worked ok, but when the link came back up, a number of phones did not switch back to the CallManager, stayed in fall back mode, ( they were pingable from the callmanagers)but the only way to fix this was to power off/on the IP Phones,

Anybody seen this before or know the cause.

2 Replies 2

kthorngr
Cisco Employee
Cisco Employee

What version of CallManger do you have?

Depending on that answer you may be running into this:

CSCdy48997 - Phones fail to register with CM when service is restored to CM

Problem Description: Phones fail to register to their primary CallManager when

service is restored to that CallManager. The phones remain in SRST mode.

Condition: Unknown, this problem does not happen to all phones at the same

remote location. Example of a branch with 10 phones, 1 phone may remain in SRST

mode. This problem is seen with phone load 408.

Workaround: Reset the phone. Reset the switch. Remove the call-manager-fallback

config from the router then readd the command.

looked up that bug,

the phones are 7940 and the CCM release is 3.1(4b), I don't know what the phone load is , as i do not have acces to the site at the moment.